Quadcopters
10 inch 25.4cm 1045 Propellers Pair
This is a set of 10×45 plastic propellers that are ideal for most multicopters. In particular, these propellers are used for Arducopter and the Arducopter 3DR frames. These sets includes one counter clockwise and one clockwise propeller.
The coloured propellers can be used to help you easily see the orientation of your multi copter/ arducopter; use different coloured propellers at the front of your flying platform to easily distinguish between the front and the rear.
₨250
CompareThe 10-inch 25.4cm 1045 Propellers Pair is ideal for twin and multiple motor RC airplanes or coaxial RC helicopters
This 1045 propeller can be used with brushless motors with an 800-2200 kV rating. With a low kV motor (800 – 1400 kV), this propeller offers smooth flights with longer flight times perfect for FPV and aerial photography. With a high kV motor (more than 1200 kV) this propeller offers fast flights perfect for acrobatic flights.
This 1045 propeller can be used with brushless motors with an 800-2200 kV rating. With a low kV motor (800 – 1400 kV), this propeller offers smooth flights with longer flight times perfect for FPV and aerial photography. With a high kV motor (more than 1200 kV) this propeller offers fast flights perfect for acrobatic flights.
- Diameter: 10 inches (25.4 cm)
Slope: 4.5 inches (11.43 cm)
Bore: approximately 3MM 4MM 5MM 6MM 7.8MM (comes with the prop shaft washer, which you can use for different shafts)
Recommended motor: 800KV – 1100KV
Based on 0 reviews
Be the first to review “10 inch 25.4cm 1045 Propellers Pair”
You must be logged in to post a review.
Related products
-
Quadcopters
Propellers 8045 (8X4.5) ABS Props 1CW+1CCW Pair
- Length : 8″.
- Pitch : 4.5″
- Weight : 20 gm
- Shaft diameter : 9.5mm
- Total length : 8 inch / 200 mm.
- Brand new and high quality.
- Model: 8 x 4.5 propeller set. (one clockwise rotating, one counter-clockwise rotating).
- Suitable for quad copter or multi-copter Aircraf
SKU: n/a -
Quadcopters
SP3 Racing F3 Flight Controller for QuadCopter/HexaCopter
- Weight ~6 grams without casing
- Acro version is without compass and barometer sensors
- STM32F303 CPU, 72 MHz inc FPU
- MPU 6050 accelerometer and gyro
- Micro USB socket
- 2×8 pin JST-SH sockets (PPM,PWM,Serial RX, GPIO, ADC,3V,5V,GND)
- 8x3pin though-holes for pin header for ESC/servo connection
- 2x4pin though-holes for pin header for 2x serial ports
- 1x2pin though-holes for pin header for battery voltage
- 1x2pin though-holes for pin header for buzzer
- 1x4pin JST-SH socket for I2C
- 1x4pin JST-SH socket for SWD debugging
SKU: n/a
There are no reviews yet.