A2212 2450KV Brushless DC Motor BLDC
KV (rpm/volt): 2450
Thrust: 1500/4
Efficiency : 90%
efficiency current: 4-16A (>85%)
Current capacity : 18A/60s
Working voltage: 7-12V
₨1,200
CompareThis is A2212 (BLDC) Brushless DC Motor of 2450KV, a high-speed brushless motor designed specifically for Quadcopters, Drones, or toy planes. This brushless DC motor is an outrunner-type motor, which means that the outside case rotates while the inside stays fixed. This A2212 2450Kv brushless motor is perfect for small DIY drones and planes.
The A2212 2450KV Brushless DC Motor is best used by DIY enthusiasts and hobbyists when the drone or quadcopter project involved is a low-cost project. You can use this brushless motor when there is a 3-phase connection to control the the speed of motor more accurately and smoothly.
Applications:
- Drones
- Quadcopters
- Multirotors
- RC Airplanes
- UAV
Specifications:
| Motor | Brushless |
| Model | A2212 |
| Kv | 2450 |
| Motor Type | Outrunner |
| Operating voltage | 7.2V to 12V (2 to 3Li-poly) |
| Maximum current | 13Amp for 60Sec |
| Shaft diameter | 3.16 mm (1/8″ size) |
| Weight | 48 grams |
Based on 0 reviews
Be the first to review “A2212 2450KV Brushless DC Motor BLDC”
You must be logged in to post a review.
Related products
-
Quadcopters
SP3 Racing F3 Flight Controller for QuadCopter/HexaCopter
- Weight ~6 grams without casing
- Acro version is without compass and barometer sensors
- STM32F303 CPU, 72 MHz inc FPU
- MPU 6050 accelerometer and gyro
- Micro USB socket
- 2×8 pin JST-SH sockets (PPM,PWM,Serial RX, GPIO, ADC,3V,5V,GND)
- 8x3pin though-holes for pin header for ESC/servo connection
- 2x4pin though-holes for pin header for 2x serial ports
- 1x2pin though-holes for pin header for battery voltage
- 1x2pin though-holes for pin header for buzzer
- 1x4pin JST-SH socket for I2C
- 1x4pin JST-SH socket for SWD debugging
SKU: n/a -
Quadcopters
Flight Controller NAZE32 Rev 6 with header pins
Naze32 rev 6 is a 32-bit ST micro workhorse of a processor, with untapped memory and CPU power and a host of equally impressive sensors. The Naze is also matched up with some of the nicest GUI programs and features to get the most out of your configuration.
SKU: n/a -
Quadcopters
10 inch 25.4cm 1045 Propellers Pair
This is a set of 10×45 plastic propellers that are ideal for most multicopters. In particular, these propellers are used for Arducopter and the Arducopter 3DR frames. These sets includes one counter clockwise and one clockwise propeller.
The coloured propellers can be used to help you easily see the orientation of your multi copter/ arducopter; use different coloured propellers at the front of your flying platform to easily distinguish between the front and the rear.
SKU: n/a
There are no reviews yet.