Shop
Showing 1–15 of 495 results
-
-
Quadcopters
10 inch 25.4cm 1045 Propellers Pair
This is a set of 10×45 plastic propellers that are ideal for most multicopters. In particular, these propellers are used for Arducopter and the Arducopter 3DR frames. These sets includes one counter clockwise and one clockwise propeller.
The coloured propellers can be used to help you easily see the orientation of your multi copter/ arducopter; use different coloured propellers at the front of your flying platform to easily distinguish between the front and the rear.
SKU: n/a -
Tools & Kits
10.1 Inch HDMI Display
Features
- 1024×600 high resolution
- Capacitive touch control
- When works with Raspberry Pi, supports Raspbian, Ubuntu, single touch, and driver free
- When work as a computer monitor, supports Windows 10/8.1/8/7/XP, single touch, and driver free
- Supports BB Black, comes with Angstrom image
- Multi video input interfaces: HDMI, VGA, and AV(CVBS)
- Multi languages OSD menu, for power management, brightness/contrast adjustment, etc.
- Supports 100-level backlight adjustment
- Firmware is upgradable to support more new features (continually updated)
SKU: n/a -
Arduino, Sensor
10KG Scale Load Cell Weight Weighing Sensor +HX711 Weighing Sensors AD Module
The module uses 24 high-precision A / D converter chip hx711, is designed for high-precision electronic scale and design, with two analog input channels, the internal programmable gain amplifier integrated multiplier 128. The input circuit can be configured to provide a bridge voltage electrical bridge (such as pressure, weight) sensor model is an ideal high-precision, low-cost sampling front-end module.
SKU: n/a -
Arduino, Raspberry Pi
16-Channel 12-bit PWMServo Driver – I2C interface – PCA9685 for Arduino Raspberry Pi DIY Servo Shield
Arduino, Raspberry Pi16-Channel 12-bit PWMServo Driver – I2C interface – PCA9685 for Arduino Raspberry Pi DIY Servo Shield
he PWM driver board uses the I2C method, so only four lines can be connected to the Arduino device:
“Classic” Arduino pin mode:
+ 5v -> VCC
GND -> GND
Analog 4 -> SDA
Analog 5 -> SCL
Old Mega pin way:
+ 5v -> VCC
GND -> GND
Digital 20 -> SDA
Digital 21 -> SCLSKU: 950