10 inch 25.4cm 1045 Propellers Pair0 out of 5(0)
This is a set of 10×45 plastic propellers that are ideal for most multicopters. In particular, these propellers are used for Arducopter and the Arducopter 3DR frames. These sets includes one counter clockwise and one clockwise propeller.
The coloured propellers can be used to help you easily see the orientation of your multi copter/ arducopter; use different coloured propellers at the front of your flying platform to easily distinguish between the front and the rear.SKU: n/a
Propellers 8045 (8X4.5) ABS Props 1CW+1CCW Pair0 out of 5(0)
- Length : 8″.
- Pitch : 4.5″
- Weight : 20 gm
- Shaft diameter : 9.5mm
- Total length : 8 inch / 200 mm.
- Brand new and high quality.
- Model: 8 x 4.5 propeller set. (one clockwise rotating, one counter-clockwise rotating).
- Suitable for quad copter or multi-copter Aircraf
A2212 1400kV Brushless DC Motor BLDC0 out of 5(0)
KV (rpm/volt): 1400
Efficiency : 90%
efficiency current: 4-10A (>85%)
Current capacity : 12A/60s
Load current @10v: 0.5A
Working voltage: 7-12VSKU: n/a
APM2.8 Flight Controller Board +Shock Absorber + M8N GPS For Rc Quadcopter Multicopter0 out of 5(0)
APM2.8 Flight Controller Board +Shock Absorber + M8N GPS For Rc Quadcopter MulticopterSKU: n/a
SP3 Racing F3 Flight Controller for QuadCopter/HexaCopter0 out of 5(0)
- Weight ~6 grams without casing
- Acro version is without compass and barometer sensors
- STM32F303 CPU, 72 MHz inc FPU
- MPU 6050 accelerometer and gyro
- Micro USB socket
- 2×8 pin JST-SH sockets (PPM,PWM,Serial RX, GPIO, ADC,3V,5V,GND)
- 8x3pin though-holes for pin header for ESC/servo connection
- 2x4pin though-holes for pin header for 2x serial ports
- 1x2pin though-holes for pin header for battery voltage
- 1x2pin though-holes for pin header for buzzer
- 1x4pin JST-SH socket for I2C
- 1x4pin JST-SH socket for SWD debugging