This is a simple-to-use MQ6 LPG Gas Sensor, suitable for sensing LPG (composed of mostly propane and butane) concentrations in the air. The MQ-6 can detect gas concentrations anywhere from 200 to 10000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple: all you need to do is power the heater coil with 5v, add a load resistance and connect the output to an ADC.
This sensor comes in a package similar to our MQ-3 alcohol sensor and can be used with the breakout board below.
Based on 0 reviews
Be the first to review “MQ-6 LPG Gas Sensor”
You must be logged in to post a review.
Related products
-
Sensors
GY-521 MPU6050 3 Axis Analog Gyro Sensor
GY 521 MPU6050 Sensor Features
- MEMS 3-aixs accelerometer and 3-axis gyroscope values combined
- Power Supply: 3-5V
- Communication : I2C protocol
- Built-in 16-bit ADC provides high accuracy
- Built-in DMP provides high computational power
- Can be used to interface with other IIC devices like magnetometer
- Configurable IIC Address
- In-built Temperature sensor
SKU: n/a -
Sensors
MQ-7 Carbon Monoxide Gas Sensor
MQ7 Gas Sensor Carbon Monoxide Sensor Features:
- Sensitive for carbon monoxide
- Output voltage boosts along with the concentration of the measured gases increases
- Fast response and recovery
- Adjustable sensitivity
- Signal output indicator
Specifications:
- Power: 2.5V ~ 5.0V
- Dimension: 40.0mm * 21.0mm
- Mounting hole size: 2.0mm
SKU: n/a -
Sensors
MQ-5 LPG Gas Sensor
MQ5 LPG Gas Sensor Features:
- Good sensitivity to Combustible gas in a wide range
- High sensitivity to Methane, Butane and Propane
- Long life and low cost
- Simple drive circuit
Specifications:
- Detection Range: 100 – 10,000 ppm iso-butane propane
- Fast Response Time: <10s
- Heater Voltage: 5.0V
- Dimensions: 18mm Diameter, 17mm High excluding pins, Pins – 6mm High
SKU: n/a -
Sensors
TCS3200 Color Sensor for Arduino
TCS3200 Color Sensor Specifications
- Single-Supply Operation (2.7 V to 5.5 V)
- High-Resolution Conversion of Light Intensity to Frequency
- Programmable Color and Full-Scale Output Frequency
- Power Down Feature
- Communicates Directly to Micro-controller
- S0~S1: Output frequency scaling selection inputs
- S2~S3: Photo-diode type selection inputs
- OUT Pin: Output frequency
- OE Pin: Output frequency enable pin (active low), can be impending when using
- Support LED lamp light supplement control
- Size: 28.4 x 28.4 mm
SKU: n/a
There are no reviews yet.