Sensors
Showing 31–45 of 70 results
-
Sensors
Light Detection Sensor Module 4-Pin
Specifications:
- Operating Voltage: 3.3V – 5V DC
- Output Type: Analog voltage
- Detection Range: 0 – 1000 Lux
- Response Time: <20ms
- Dimensions: 20mm x 15mm x 5mm
- Operating Temperature: -20°C to 85°C
- Output Pin Configuration: VCC, GND, Signal, NC (No Connection)
- Photodiode Type: Silicon NPN phototransistor
- Signal Output Voltage Range: 0V to VCC
- Applications: Automatic lighting, brightness control, smart appliances, robotics, environmental monitoring.
SKU: n/a -
Sensors
LM35 Temperature Sensor
LM35 Temperature Sensor Specifications:
- Calibrated Directly in Celsius (Centigrade)
- Linear + 10-mV/°C Scale Factor
- 0.5°C Ensured Accuracy (at 25°C)
- Rated for Full −55°C to 150°C Range
- Suitable for Remote Applications
- Low-Cost Due to Wafer-Level Trimming
- Operates from 4 V to 30 V
- Less than 60-µA Current Drain
- Low Self-Heating, 0.08°C in Still Air
- Non-Linearity Only ±¼°C Typical
- Low-Impedance Output, 0.1 Ω for 1-mA Load
SKU: n/a -
Sensors
LM35 Waterproof Temperature Sensor
LM35 Waterproof Temperature Sensor Specifications:
- Directly Celsius temperature calibration;
- Linear :+ 10.0mV / ℃;
- Ensure the accuracy : 0.5 ℃ (at + 25 ℃ when);
- Temperature range : 0 ℃ ~ 100 ℃
- Direct output voltage signal;
- Internally precision fine-tuning;
- Wide supply voltage:4 ~ 30V;
- Operating current: Less than 60μA;
- Low self-heating, in still air 0.1 ℃;
- Only non-linear value ± 1/4 ℃ of;
- Low-impedance output, 0.1Ω at 1mA load
SKU: n/a -
Sensors
Mics6814 Carbon Monoxide Nitrogen Oxygen Compact Sensor Co/No2/Nh3 in Pakistan
Product Description
The MiCS-6814 is a robust MEMS sensor for the detection of pollution from automobile exhausts and for agricultural/industrial odors
Features:- Three gas detection
- Carbon Monoxide/Nitrogen Dioxide/Ammonia
- Surface Mount Package
SKU: n/a -
Sensors
MQ-135 Air Quality Gas Sensor
Specifications of MQ135 Gas Sensor:
- Wide detecting scope
- Fast response and High sensitivity
- Stable and long life Simple drive circuit
- Used in air quality control equipment for buildings/offices, is suitable for detecting
of NH3, NOx, alcohol, Benzene, smoke, CO2, etc. - Size: 35mm x 22mm x 23mm (length x width x height)
- Working voltage: DC 5 V
- Signal output instruction.
- Dual signal output (analog output, and high/low digital output)
- 0 ~ 4.2V analog output voltage, the higher the concentration the higher the voltage.
SKU: n/a -
Sensors
MQ-3 Alcohol Gas Sensor
MQ3 Alcohol Gas Sensor Specifications and Features:
- Model No.: MQ-3
- Dimensions: 36 x 20 x 21 mm (LxWxH)
- Weight: 6gm
- Heater voltage: 5±0.2V (AC•DC)
- Loop voltage: ≤24V (DC)
- Load resistance: Adjustable
- Heating Resistance: 31Ω±3Ω (Room temperature)
- Heating Power: ≤ 900mW
- Surface thermal resistance: 2Kohm-20Kohm (0.4mg/L alcohol)
- Sensitivity: Rs (in the air)/Rs (0.4mg/L alcohol) ≥ 5
- Working temperature: 20 degrees ±2 degree
- Humidity: 65%±5%RH
- Signal output light indicator.
- Analog and level signal output.
- TTL output valid signal is low. (When the output low signal light can be directly connected microcontroller or relay module).
- The carbon monoxide detection with better sensitivity.
- Has a long service life and reliable stability.
- Rapid response recovery features.
SKU: n/a -
Sensors
MQ-5 LPG Gas Sensor
MQ5 LPG Gas Sensor Features:
- Good sensitivity to Combustible gas in a wide range
- High sensitivity to Methane, Butane and Propane
- Long life and low cost
- Simple drive circuit
Specifications:
- Detection Range: 100 – 10,000 ppm iso-butane propane
- Fast Response Time: <10s
- Heater Voltage: 5.0V
- Dimensions: 18mm Diameter, 17mm High excluding pins, Pins – 6mm High
SKU: n/a -
Sensors
MQ-7 Carbon Monoxide Gas Sensor
MQ7 Gas Sensor Carbon Monoxide Sensor Features:
- Sensitive for carbon monoxide
- Output voltage boosts along with the concentration of the measured gases increases
- Fast response and recovery
- Adjustable sensitivity
- Signal output indicator
Specifications:
- Power: 2.5V ~ 5.0V
- Dimension: 40.0mm * 21.0mm
- Mounting hole size: 2.0mm
SKU: n/a -
Sensors
MQ131 Gas Sensor
The sensitive material of the MQ131 gas sensor is SnO2, which with lower conductivity in clean air. The sensor’s conductivity is higher along with the gas concentration rising.
<script src="moz-extension://f26db0f4-f100-4dfb-9692-7da94f91d630/js/app.js" type="text/javascript">
SKU: n/a
