Based on 0 reviews
Be the first to review “Load Cell Sensor Weighing Sensor”
You must be logged in to post a review.
Related products
-
-
Modules and Motors, Arduino
ZMPT101B 250V AC Voltage Sensor Module For Arduino
Specifications:
- Measure within 250V AC
- Onboard micro-precision voltage transformer
- Analog output corresponding quantity can be adjusted.
- Good consistency, for voltage and power measurement
- Very efficient and accuracy
SKU: n/a -
Modules and Motors, Arduino, Raspberry Pi
TM1637 LED Display Module Tube For Arduino Raspberry PI
TM1637 LED Display Module Specifications:
- Using CMOS technology
- Display mode (6-Digit 8 Segment), support a total of positive digital tube output
- Key scan (8X2bit), enhanced anti-jamming key recognition circuit
- Gray scale adjustment circuit (duty cycle 8 adjustable)
- Two-wire serial interface (CLK, DIO)
SKU: n/a -
Sensors, Arduino, Modules and Motors
801S Vibration Shock Sensor For Arduino
801S Vibration Shock Sensor For Arduino Specifications:
- Operating Voltage: 3.3V – 5V DC
- Current Consumption: <1mA
- Output Type:
- Digital Output: High/Low (TTL)
- Analog Output: 0V to Vcc (0 – 5V)
- Detection Range: Adjustable via sensitivity potentiometer
- Frequency Response: 10Hz – 10kHz
- Dimensions: 32mm x 14mm x 7mm
- Mounting Holes: Two mounting holes for easy integration into various projects.
- Operating Temperature: -10°C to +70°C
- Interface: 3-pin interface (VCC, GND, Signal)
- Compatibility: Compatible with Arduino and other microcontrollers with digital and analog input capabilities.
SKU: n/a -
Modules and Motors
HC06 HC09 Bluetooth Module
HC06 HC09 Bluetooth Module firmware are the modules which are factory set to be Master or Slave modules. Master and slave mode cannot be switched from the factory setting. HC-04 is an industrial grade product, HC-06 is a commercial grade product.
The modules with the HC-09 firmware are replacements for the HC-06 and HC-07 modules.
SKU: n/a
There are no reviews yet.